Error Code 0x00000037

Error Code 0x00000037

« Back to Glossary Index
Email
Twitter
Visit Us
Follow Me
LINKEDIN
Share
Instagram

The “FLOPPY_INTERNAL_ERROR” (0x00000037) error usually appears when there’s an issue with the floppy disk or floppy disk controller on your system. This error is not as common in modern computers since floppy disks are rarely used today.

How to fix:

  1. Check the floppy disk and drive: If you are using a floppy disk, ensure that the disk is not damaged and the drive is functioning properly. If possible, test the disk and the drive on another system.
  2. Disable the floppy disk controller in BIOS: If you’re not using a floppy disk drive but still see this error, your system BIOS may be misconfigured. You can access your system’s BIOS during startup and disable the floppy disk controller.
  3. Update your system BIOS: An outdated BIOS could be causing this issue. Check your motherboard manufacturer’s website for any BIOS updates. Be sure to follow the instructions carefully, as improper BIOS updates can cause major issues.
  4. Check for hardware issues: If you’ve been experiencing other hardware-related issues, your hardware might be faulty. If possible, test your hardware on another system or use diagnostic tools to check for problems.
  5. Perform a clean boot: This will start your system with a minimal set of drivers and services. If the error doesn’t occur during a clean boot, it means a third-party software or service is causing the error. You can then enable the services one by one to find the culprit.
  6. System Restore: If the issue started happening recently, you can perform a system restore to a point where the error did not occur.

Remember to back up your data before attempting these solutions. If the problem persists, consider reaching out to a professional.

You may also like...